Setting the Network & TCP/IP address

You can connect iGuard directly to your corporate network. To do so, you would need to assign a device name & an IP address to the product. It is possible to use the DHCP server in your network to dynamically assign the IP address, but it is suggested to assign a static IP address to the product to avoid problems.

The following procedures show you how to assign the name, the IP addresses, and other related settings. Collect all the information before proceeding.

Description

LCD Display

  • While in Standby Mode, press the Func key to enter the Setup Menu. You will be prompted to enter the Administrator Password (default:. 123) as shown.

Enter Password: _

  • Enter 5 to select the System Configuration menu.

Press 1: Add/Update ID





:


:



Press 5: System Configuration..

  • Pressing the Func key until you see “DHCP/Static IP”


  • Press Func key to continue, and then press 1 to select DHCP or 2 to select Static IP.

DHCP/Static IP (1/2)? Static


  • Press Func key to continue. You will then be asked to enter the IP address of the device. The default is 192.168.0.100. Enter the static IP address assigned to the device (e.g., 192.168.1.123).Note: Please configure the IP according to your corporate network.

IP Address: 192.168.001.123

  • Press Func key to continue. Enter the sub-net mask here (e.g., 255.255.255.0).

Subnetmask: 255.255.255.000

  • Press Func key to continue. Enter the address of the Default Gateway (e.g., 192.168.0.200).

DefaultGateway: 192.168.000.200


  • Press Func key to continue. Enter the address of the Domain Name Server (e.g., 192.168.0.200). Make sure that the IP address of all units are unique. (Warning: IP addresses that are not unique will cause network error and the iGuard would not function.

DNS: 192.168.000.200

  • Press Func key to continue. You will be asked if the device is a Master or Slave device (1/2)? If you have only one unit of iGuard, choose (1) Master. If you have more than one units of iGuard, you have to decide which is the Master and which are the Slave(s). If you choose (2) Slave, the system will ask you to provide the Master IP Address, key in, default: 192.168.0.100. Please also read the section about Master and Slave mode.

Master/Slave (1/2)? Master

  • iGuard FPS110 can be configured as Master or Slave device. Select one and then press Func key. The system will reset itself and then return to Standby Mode.

Mon Aug 30 13:46 ID #:_